PMC (Polyurea Machine Corporation) was founded in February of 2007. Its combined management has over 100 years of experience in the urethane industry for high quality plural-component systems. PMC carries complete product lines for urethane spray systems. These include, but are not limited to: proportioning units, uniquely-designed heated hose system, transfer pumps, spray guns, and the auxiliary equipment required of industry contractors. PMC offers spray foam, pour foam, Polyurea and Polyurea hybrid coatings manufactured in the USA. PMC’s motto, “designed with the customer in mind”, is descriptive of its dedicated to helping customers successfully, economically, and competitively apply residential and commercial coatings. PMC products and innovations have arisen as a direct result of customer input, creativity, and the spirit of perfection its engineers put into all of its product lines.
In 2010, PMC introduced the “classic” GH Series of hydraulic foam and coatings proportioners that featured a relay logic control system and point-to-point wiring, incorporating the highest industry standards for hydraulic drive systems, metering pumps, and chemical heaters. In 2012, PMC introduced the next generation of “Classic” PH Series proportioners. The PH Series offers the same heating and pumping systems as the GH Series; however, it features console enhancements, such as a solid-state reversing system as well as the ability to pre-set the machine in order to turn it off at a prescribed cycle count. This eliminates cavitation that is caused when chemical drums become empty.
How to Rebuild a PMC Pump PMC's New AP-EX Spray Gun
How to Disassemble a PMC AP-2 Spray Foam Gun How to Reassemble a PMC AP-2 Spray Foam Gun
How to Put a Scuff Jacket on
Heated Spray Foam Hoses InsulRight Using PMC Blaster Tip
Visit us at: POLYMAC-USA.COM
One Komo Drive
Lakewood, NJ 08701
Two Komo Drive
Lakewood, NJ 08701